Sliding gate motor
Sliding
Gate
Motor
Gate
Hinges
Range of gate Hinges
keypads for gates
Keypads
swing gate electric lock
Swing Gate Electric
Lock
Swing Gate Motors
Swing gate motors
How does ECOSOL work?When a BFT 24VDC Gate Automation Solution is connectedto a solar panel, the most important factor beyond reliability is to consume the least amount of power both during the gate operation and in standby mode, while keeping the necessary safety devices and functions activated. BFT has managed to achieve both these goals with the development of the revolutionary ECOSOL board.

Revolutionary   Technology  
-   ECOSOL   Board:The  BFT  Ecosol  System  has  been  designed  with  enhanced  technology  that  puts  the  BFT  Control  Board  to  sleep  when  not  in  use  for  more  than  5  minutes.  This  provides  for  an  optimized system that allows for minimal power consumption from  the  batteries  throughout  the  day.  The  result  is  an  ultra  efficient  system  that  will  provide  optimized  results  even  in  geographical  areas  that  are  not  in  bright  sunlight  every  day.  The  ECOSOL  control  board  can  be  woken  up  by  an  impulse  of a BFT Mitto remote control device, BFT T-Box radio digital keypad, BFT wall radio switch, wired keypad or a loop detector to open the gate.

BFT 24V DC Operators: BFT operators draw minimal power  when  activating  a  gate;  for  example,  a  Phobos  BT  24VDC electromechanical linear arm, or an Igea BT 24VDC articulated  arm  for  swinging  gate  applications  consume  a  maximum of 40 watts for gates up to 250 kgs. A Deimos BT24VDC for rack & pinion sliding only a maximum of 70 watts for gates up to 550 kgs.

Solar Panel:New Phobos BT operators have been designed specifically for ECOSOL. Speed for opening 90 degrees with standard geometry and full batteries: ECOSOL Phobos BT: 14 seconds,  ECOSOL  Phobos  BT  L:  19  seconds,  ECOSOL  Igea  BT:  15  seconds.  A  highly  efficient  small  in  size  10W,  24V  solar panel is supplied by BFT to quickly charge the batteries. For higher traffic or low sun exposure, it is an option to add a set of larger capacity batteries and/or one or two extra solar panels.  The  panel  can  be  wall  mounted  or  post  mounted  (optional bracket necessary).

1.An ECOSOL control box with a handle and rapid connectors, including 2-7.2Amp/h batteries (a secondbattery box can be added for increased capacity in lowsun exposure areas)

2.An ECOSOL 12” x 14” pre-wired enclosure with LibraUL/CSA control panel, including 2-9Amp/h batteries(2 additional 9Amp/h batteries can be connected andadded inside the enclosure for increased capacity in lowsun exposure areas) All  BFT ECOSOL  kits,  slide  or  swing,  single  or  dual  operators   come   in   only   two   boxes   including   necessary   installation accessories.
Number of Cycles* ( Cycle = 1 operation )
ECOSOL has been designed for residential or low traffic applications.
• 10 cycles per day – 21 days without sun
• Up to 3 10W BFT ECOSOL solar panels can be connected to one ECOSOL board
• Choice of 2 or 4 x 7.2 Amp/h (standard on ECOSOL Interface box) or2 or 4 9 Amp/h (standard on ECOSOL Libra UL/CSA enclosure)batteries for greater capacity
• 30+ cycles per day in optimum conditions

* Note: Based on one Single Phobos BT operator with FL 130B Photocells. Conditions may vary from installation to installation and alternative results may occur dependenton environmental conditions and geographical position
ecosol Dimensions
ecosol box door open

Solar gate Automation Solution

  Related Products
bft solar system
Delivering
Australia-wide
and WorldWide
Delivering
Around Australia Daily
deliveryman
dhl logo
Australian Post
tnt logo