<<<Menu
Used as a safety device. Protects by sensing person or vehicle in danger zones. Operate at a distance up to 295'. When infrared beam is broken it produces a detection signal to stop or reverse a gate. Used primarily with gate operators. Can be used in sets to protect all areas of entrapment
Applications:
1. Gate Automation
2. Overhead door
3. Swing gate
4. Sliding door
5. Perimeter Protection
6. Window Security Protection
7. Terrace
8. Warehouse
9. Parking lot
10. Entry Alert

Just think of the unpleasant results of you driving your car through your gate, when it suddenly decides to close! With a photo cell, anything that breaks the beam will stop and reverse the gate. And when we say anything, we mean anything, people included! I rate this as a must have option for any gate.
Tip:
On most gate motors there is a special outlet for Photo Safety Beams on the control board.


Normally Open” and “Normally Closed” are words that you'll come across when many accessories to gate motors.

“Normally Closed”
Designation which states that the contacts of a switch or relay are closed or connected when at rest. When activated, the contacts open or separated.

Use “Normally Closed” when installing Photo Safety Beams! When someone passes through the inferred beam the circuit is broken.

“Normally Open”: Designation which states that the contacts of a switch or relay are normally open or not connected. When activated the contacts close or become connected

Non Polarity means they are reversible.
When wiring photo cells to your gate you will require 4 wire cables: 2 for power, 1 to common (earth) and 1 for normally closed outlets on the control board.
ET405 - Infrared beam security beam sensor.
(Waterproof)


the PE sensor is safety beam sensor, Are used on gates and garages opening systems to stop the gates from closing on a car, person or objects,
Specifications
Detection technology: Infrared
Range: 15m
Frequency: 1.92Khz
Power: 12-24V AC/DC
Wave Length: 940mm
Input: RX 15mA, TX 30mA
Operating temperature: -20 to 70 degrees
Relay output: 1Amp max 30V
Dimension: 49.2 x 76 21mm
Please note:
The range give above may vary
according to the
site environment
conditions and
according to the weather


NOTE.. Does not work with  ATA, Marantec, Merlin, and Boss Brand gate motors they require a 3 wire system with a Resistor.
Infrared safety beams
$59.00
Code -  ET405
  Related Products
gate closer
Pedestrian
Gate Closer
Sliding
Gate
Motor
Sliding gate motor
keypads for gates
Keypads
Swing Gate Motors
Swing gate motors
free shipping
photo safety beams for swing gate motors
Photo Safety Beams
are sold in a Pair
One to send
and
One to receive
TX
RX
Transmitter
Receiver

Infrared beam security beam sensor

Delivering
Australia-wide
and WorldWide
 
Delivering
Around Australia Daily
dhl logo
Australian Post
tnt logo
deliveryman